How do I fix a dripping tap?

Faucet leakage repair method:

1, about the faucet joint leakage repair, the reason for the leakage is nothing but the sealing tape (fixing screw) attached to the faucet part is damaged. Therefore, just remove the tap with a plate clamp and roll the new sealing tape on the fixing screw part.

2.Tighten the tap and turn the tap anti-clockwise with pliers.

3, threaded holes to the outside, in the threaded part of the wind roll printing tape clockwise 5-6 times.

4,Check whether the tap is adjusted and tighten it with pliers in clockwise direction.

5,After the installation is completed, turn over the main switch to try, admit to see whether there will be water leakage.

Faucet leakage causes:

1, spout leakage cause: it is caused by the faucet axial washer wear. Unscrew the gland bolts with pliers, remove the axial gasket with a clamp and replace the axial gasket with a new one.

2, tap the lower end of the gap leakage causes: is the gland on the triangular sealing gasket wear caused by. You can loosen the screws to remove the bolt head, loosen the gland to remove the gland, and then remove the inner triangle seal of the gland and replace it with a new one.

3, joint leakage: cover nut loose, cover nut can be re-tightened or replaced with a new u-shaped gasket.

4, if you find a tap with little water, it may be a leak, because the single shot tap plate card sand, this phenomenon is still looking for professional maintenance engineers to remove the tap, but if the rubber gasket is damaged, it needs to be replaced. In general, the correct use of taps, the key is not too tight faucet rotation, faucet rubber gasket can keep 7, 8 years of service life.

If you want to know more information, please contact sales2@cx-hoses-fittings.com.