Shower cleaning and maintenance knowledge

Shower cleaning

1,Now on the market most of the shower spout are made of silicone, its soft touch easy to clean, just use your fingers to wipe, you can easily go to rub the accumulated scale, and then open the water can be flushed out.

2,Unscrew the shower head cover, remove the internal mesh or spout parts, with a brush or toothbrush for cleaning. Some brands of showerheads are equipped with a special showerhead opening tool, easy to open and use.

3,Part of the shower has a special structure, such as some shower holes with a thimble, press the button to pop the thimble, automatically bring out the scale.

4,Bubble with vinegar. If the shower head clogging is more serious, you can use the acidification method to solve the problem, that is, pour white vinegar into the basin, the shower head submerged in white vinegar, ten minutes or so you can remove the scale in the shower head.

5,Puncture with a needle. If the shower head is partially blocked, you can first drain the water, and then use the needle to block the small hole in the impurities pierced until the hole is no debris until, but be careful not to shower holes to the bad.
6,With lubricants. If the shower head metal rust caused by the clogging, you can use rust rust lubricant, it has a very good affinity and permeability, can be separated from the rust layer and the metal layer, and leave a protective film to prevent rust again.

Shower maintenance

1,Do not use steel ball and other hard objects to wipe the surface of the shower, so as not to scratch the surface of the faucet.
2,Or the electroplated surface of the shower, you can regularly wipe with flour first, and then rinse with water, so that the surface of the shower can be bright as new.
3,Remove limescale must not use strong acid, so as not to cause corrosion on the surface of the shower.
4,The use of environmental temperature can not exceed 70 degrees Celsius, high temperature and ultraviolet light will greatly accelerate the aging of the shower, shorten the service life of the shower, so the installation of the shower as far as possible away from the heat source of the bath and other electrical appliances. Shower can not be installed in the bath directly below, and the distance should be more than 60CM.
5,In the hard water areas, please try to use with rubber particles or with a straight cleaning device with a shower hole, even if the shower hole is clogged with scale, but also relatively easy to clean up. Remember not to dismantle the shower, due to the complexity of the internal structure of the shower, non-professional forced dismantling will result in the shower can not be restored to its original state.

6,Switch the shower faucet and adjust the way the water out of the shower do not force too much, gently turn along the trend can be. Even the traditional faucet, also do not need to spend a lot of force. Special attention should not be faucet handle, shower bracket as a handrail to support or use.
7,The metal hose of the shower head should keep the natural stretch state, do not coil it on the faucet when not in use. At the same time, pay attention to the hose and faucet joints do not form a dead end, so as not to break or damage the hose.